711 Epoxy Floor Primer

Product Introduction:

This product uses epoxy resin as the main resin, mixed with polyamide hardener to form a transparent primer. The coating film has excellent adhesion, flexibility, chemical resistance, and low toxicity, and exhibits good resistance to acids, alkalis, oil stains, solvents, and moisture.

characteristic:

1. The coating has excellent flexibility and adhesion.
2. Excellent chemical tolerance

use:

It provides surface protection for concrete floors and cement products, and can also be used as an excellent primer for floor coatings and cement wall coatings.

Product characteristics:

Viscosity: 46 ± 5 KU (25 ℃ )

Specific gravity (g/ml) : 0.96 ± 0.05 (g/ml)

Volumetric solids (%) : 38 ± 1%

Color: Colorless and transparent

Hardener ratio: A : B = 3 : 1 (by weight)

Thinner included: 926D

Recommended number of coats: 1

Drying time :

Min ( minutes ) , H ( hours ) , D (days)	30 ℃
Touch time	4H
Hardening time	24H
Repaint interval ( lowest )	8H
Recoat interval ( max )	2D
Usable time	6H

Drying time will vary depending on the ambient temperature and humidity.

Theoretical coverage:

Typical: 12.6 m²/L/coat (dry film thickness: 30 μm ( per coat ) )

The actual amount of paint applied will vary depending on factors such as the condition of the ground, the type of paint, the gloss, and the color.

Instructions for use:

Surface treatment

The surface to be worked on must be flat and dry.

Before construction, moisture, grease, old or damaged coatings, and other contaminants must be removed from the surface.

Paint preparation

Stir well before use, and mix thoroughly with the hardener as recommended in the instructions.

Under normal circumstances, no thinner needs to be added (if necessary, a matching thinner can be added, but the amount added should be less than 5% ).

Storage:

Storage validity period: 12 months

This product must be stored in a cool, dry, and well-ventilated place, away from direct sunlight and fire.

Notes:

Please read the paint instructions carefully before application.

The paint should be thoroughly stirred after opening the can.

Strictly follow the dilution ratio specified in the instructions; do not dilute excessively.

Please mix the main agent and hardener thoroughly according to the proportions indicated in the instruction manual.

Any grease, moisture, or dust on the construction surface must be thoroughly cleaned, and the moisture content of the substrate must be less than 8%.

This product is flammable and should be kept away from heat sources and open flames.

The work area should be well-ventilated during construction, and workers should avoid contact with skin and eyes. Please refer to SDS for relevant information.

Do not use when the temperature is below 5 °C or the relative humidity exceeds 85%.

Unused main agent and hardener should be sealed separately and stored in a cool place.

Epoxy floor coatings may fade or change color under sunlight, which is a normal reaction and does not affect their quality or performance.

Packaging specifications:

Supporting specifications:	18.0	L
Supporting specifications:	3.6	L

Safety Precautions:

1. Ensure good ventilation during application, and keep the paint away from direct sunlight and heat sources.
2. To avoid contact with skin and eyes or inhalation of excessive paint fumes, please use protective equipment such as a face mask and gloves.
3. If it gets into your eyes, rinse immediately with plenty of water and seek medical attention.
4. Keep out of reach of children.

Disclaimer:

The above information represents typical properties, characteristics, and applications of the product and is intended only as guidance from our company. It should not be considered a warranty, a statement requiring the company to assume legal liability, or a basis for presuming the company to be liable. Users are responsible for confirming the suitability of any batch of product for a specific application before using the information and content presented in this manual.